FAG Bearing Covers, Seals

[Specifications]・Inner Diameter(mm): 184.3~274.4Labyrinth seal, split.

[Specifications]・Material: Steel, FKM・Inner Diameter(mm): 42.7~184.2・Outer Diameter(mm): 42.7~184.2Labyrinth seals TSV give non-contact sealing. They are therefore suitable for high circumferential velocities. The O ring, which is pressed between the labyrinth ring and shaft, is made from fluoro rubber FKM and is suitable for temperatures of up to +200 °C. The labyrinth seal allows shaft misalignment of up to 0,5° in both directions.

[Specifications]・Material: Steel, NBR・Width(mm): 265~426Bolt-on seal, unsplit.

Labyrinth seal; ETS; SES-housing

Seal set for hydraulic nuts HYDNUT..-HEAVY

Labyrinth seals NTS, sealing for SNS-housing, non-contacting sealing.

[Specifications]・Type: DKV, NDK・Inner Diameter(mm): 46.5~436・Outer Diameter(mm): 44~436

[Specifications]・Outer Diameter(mm): 39.5~212.5・Shaft Diameter [d](mm): 20~140Felt seals; EFS; SES-housing

Two lips seal EDH, for SES housings

Taconite seals NTC, for SNS-housing, kombined sealing

In the case of V ring seals DHV, the seal lip is in axial contact with the sliding surface which is located in the rectangular section annular slot of the housing. The seal is made from NBR and is suitable, when using grease lubrication, for circumferential velocities of up to 12 m/s. If circumferential velocities of more than 8 m/s are present, axial location is necessary. The seal allows shaft misalignment of up to 0,5° in both directions.

[Specifications]・Engineering material: Plastic・Model series: DKV..

[Specifications]・Model series: FSV..・max. inclination(°): 0.5

[Specifications]・Material: Steel・Width(mm): 265~585

[Specifications]・Material: Steel, NBR・Inner Diameter(mm): 160~400・Outer Diameter(mm): 270~520Taconite seal, unsplit.

[Specifications]・Material: Steel, FKM・Inner Diameter(mm): 35.4~434.4・Outer Diameter(mm): 184.3~434.4Labyrinth seal, unsplit.

Felt seals FSV are particularly suitable for grease lubrication. They comprise an adapter holding the inserted, oil-impregnated felt strip and the adapter is secured against rotation by an O ring in the annular slot in the housing. The seals are suitable for circumferential velocities of up to 5 m/s and, after running-in, of up to 15 m/s. They can be used at temperatures up to +100 °C. The permissible shaft misalignment is 0,5° in both directions.

Seal set for hydraulic nuts HYDNUT..-E and HYDNUT..-E-INCH